Introduction to Battlefront
Paints & Decals
Product Assembly Guides
Purchase these Items
Products mentioned in this Article
GBX127 Ferdinand Tank Hunter Platoon
Building a V1 Rocket Launch Site
Assembling The Lorraine Schlepper (GE149)
Oil War! Painting Iraqi Armour
Assembling The S307(f) (7.5cm) (GE214)
Assembling The Reihenwerfer (8cm) (GE212)
Assembling The Hotchkiss (7.5cm) or (10.5cm)
Assembling the Parachutist 47mm Anti-tank (IT563)
Assembling the Parachutist Mortar Platoon
Assembling The Marder II (7.5cm) Tank-hunter (GE103)
Assembling the Parachutist Breda MG Platoon
Begin assembly of the Ferdinand by attaching left-side tracks to the hull.
attach the right-side tracks to the hull.
The tracks in place.
Next, attach gun barrel to the upper hull section. Note that the mantlet makes an unside down T in the correct position.
Next place the square hatch into the sqaure slot.
Now you can place the closed comanders hatch in place.
Skip this step
if you wish to have a tank comander with the hatch open.
Cut the comanders round hatch in half and glue the two sperate peices onto the hull then pace the commander of your choice in the open tank hatch.
A fully assembled Ferdinand.
Last Updated On
Friday, February 1, 2019
by Luke at Battlefront
Battlefront Miniatures 2006-2019. Website by