Assembling the 7.5cm Anti-tank Gun

Step 1. Begin assembly of the 7.5cm anti-tank with the the gun trail. Start by attaching the wheels to either side of the gun trail. Tip: Always dry fit (Dry Fitting is assembling components of a model without any glue. This ensure that they go fit together correctly before a permanent bond is created and allows for any fine adjustments to be made.) components before final assembly. Below: The gun trail of the 7.5cm anti-tank gun.

Below: Attaching a wheel to the right-hand side of the gun trail. Tip: When refer to left or right-hand side in regards to a Flames Of War miniature, the orientation is determined as if looking at the gun from the rear.

Below: Attaching the wheel to the left-hand side of the gun trail.	Step 2. Next, attach the front plate to the front of the gun trail. Tip: The front of the gun trail has two small pegs to assist in the correct alignment of the front plate.

Below: The front plate attached to the gun trail correctly. Note: The head of the shovel should point towards the left.	Step 3. Next, attach the gun to the gun trail.

Step 4. Attach the gun shield by sliding it into position over the gun barrel.	Below: With the gun shield in place, the 7.5cm gun is ready for its crew.