Introduction to Battlefront
Paints & Decals
Product Assembly Guides
Purchase these Items
Products mentioned in this Article
SBX43 M3 Stuart Tank Company (Plastic)
Building a V1 Rocket Launch Site
Assembling The Lorraine Schlepper (GE149)
Oil War! Painting Iraqi Armour
Assembling The S307(f) (7.5cm) (GE214)
Assembling The Reihenwerfer (8cm) (GE212)
Assembling The Hotchkiss (7.5cm) or (10.5cm)
Assembling the Parachutist 47mm Anti-tank (IT563)
Assembling the Parachutist Mortar Platoon
Assembling The Marder II (7.5cm) Tank-hunter (GE103)
Assembling the Parachutist Breda MG Platoon
Begin assembly of the Stuart by attaching the right-hand side track to the hull section.
Next, attach the left-hand side track to the hull section.
Both tracks in place.
Next, attach the hull rear piece to the rear of the hull section.
Mount the upper hull on the lower hull assembly.
Attach the glacis.
Glacis in place.
Choose an open or closed turret piece.
Assemble the main turret pieces.
Attach the main gun to the turret.
ttach the MG to the turret.
Glue your choice of commander in to the open hatch. (American commander shown)
Commander in position.
You can choose a magnet sleeve or turret peg.
Glue the pet in place.
Mount the turret on to the hull assembly.
A fully assembled M3 Stuart.
You may wish to attach fuel tanks, as seen below.
The sprue also features a flamethrower for building
Last Updated On
Sunday, August 26, 2018
by Charlie at Battlefront
Battlefront Miniatures 2006-2019. Website by