Introduction to Battlefront
Paints & Decals
Product Assembly Guides
Purchase these Items
Products mentioned in this Article
SUAB10 'Kutusov's Heroes' Army Deal (Plastic)
SBX54 T-34 Tank Company (Plastic)
Building a V1 Rocket Launch Site
Assembling The Lorraine Schlepper (GE149)
Oil War! Painting Iraqi Armour
Assembling The S307(f) (7.5cm) (GE214)
Assembling The Reihenwerfer (8cm) (GE212)
Assembling The Hotchkiss (7.5cm) or (10.5cm)
Assembling the Parachutist 47mm Anti-tank (IT563)
Assembling the Parachutist Mortar Platoon
Assembling The Marder II (7.5cm) Tank-hunter (GE103)
Assembling the Parachutist Breda MG Platoon
Carefully cut the hull top and bottom from the sprue using clippers.
Use a craft knife to gently scrape away any excess plastic.
Run a line of plastic cement around the top of the hull bottom piece.
The hull top piece has raised lines to help ensure correct placement.
Press the hull top and bottom pieces together. Note the two locator slots for the left-hand track...
...and the single locator slot for the right-hand track.
The tracks have corresponding tabs, so you can't put the tracks on the wrong sides.
Glue both tracks in place using plastic cement.
Select the appropriate mudguards.
The rounded mudguards were common on 76mm models and 85mm variants up to late 1944.
Glue the mudguards in place, taking care to ensure they are straight.
Carefully clip off the exhaust pieces.
Apply a small amount of plastic cement to each locating hole and press the exhausts into place; you may want to use tweezers for this.
Clip off the bow MG. The stubbier piece next to it is for the flamethrower variant.
Apply a small amount of plastic cement to the locating hole and press the MG into place.
Combine the two turret pieces.
Glue on the gun mantlet for the 76mm gun
Add the 76mm gun barrel to the mantlet on the turret.
Finish by adding the turret to the hull assembly using either a turret peg or magnet.
Last Updated On
Thursday, November 22, 2018
by Luke at Battlefront
Battlefront Miniatures 2006-2019. Website by