|
 |
|
 |
Wirblewind/Ostwind Parts Required
Colour |
Figure Type |
 |
Required For All Variants |
 |
Wirblewind Parts |
 |
Ostwind Parts |
|
Step 1. Begin assembly of the Ostwind by attaching the lower front hull section to the front of the hull. |
Step 2. Next, add the spare track links to the front of the lower hull. |
 |
 |
 |
Below: The spare track links in place. |
Step 3. Attach the rear hull plate to the back of the lower hull. |
 |
 |
 |
Step 4. Next, attach the exhaust muffler to the rear hull plate. |
Step 5. Attach the top hull section to the lower hull section of the Ostwind. |
 |
 |
 |
Below: The two hull sections successfully joined. |
Step 6. Next, attach the left-hand side track to the lower hull section. |
 |
 |
 |
Step 7. Attach the right-hand side track to the lower hull section. |
Below: The completed Hull. |
 |
 |
Step 9. Attach the 3.7cm gun to turret base plate.
Note if this fails to fit make sure you have correctly assembled the gun.
|
Step 10. Attach the upper turret armour to the turret assembly. |
 |
 |
Below: The short 7.5cm gun mantlet in place. |
Step 11. Finally, attach the short 7.5cm to the gun mantlet. |
 |
 |
Step 1. Begin assembly of the Wirblewind by attaching the lower front hull section to the front of the hull. |
Step 2. Next, add the spare track links to the front of the lower hull. |
 |
 |
 |
Below: The spare track links in place. |
Step 3. Attach the rear hull plate to the back of the lower hull. |
 |
 |
 |
Step 4. Next, attach the exhaust muffler to the rear hull plate. |
Step 5. Attach the top hull section to the lower hull section of the Wirblewind. |
 |
 |
 |
Below: The two hull sections successfully joined. |
Step 6. Next, attach the left-hand side track to the lower hull section. |
 |
 |
 |
Step 7. Attach the right-hand side track to the lower hull section. |
Below: The completed Hull. |
 |
 |
Step 8. Next, attach the left-side hull plates to the main hull. Note that there are notches to help you correctly place it.
|
 |
 |
Step 9. Next attach the right-side hull plates to the main hull. Note that there are notches on the hull plates to help you correctly place it.
|
 |
 |
Step 10. Glue the Quad AA (2cm) guns to the gun mount. |
Step 11. Next attach the manlet to the lower turret platform. |
 |
 |
 |
Step 12. Glue the Quad AA (2cm) guns to the main turret hull. |
Step 13. Glue the turret hull armour to the turret assembly. |
 |
 |
Below: The Assembled Quad AA (2cm) Gun Turret. |
Below: The fully assembled Wirblewind AA Tank. |
 |
 |
Last Updated On Thursday, March 11, 2021 by Luke at Battlefront
|
|
|