Assembling The Marder II (7.5cm) Tank-hunter (GE103)

Assembling The Hotchkiss (7.5cm) or (10.5cm)

How to assemble your Hotchkiss (7.5cm).

Check out the Hotchkiss (7.5cm or 10.5cm) spotlight here...

Step 1. Begin assembly of the Hotchkiss by attaching left -side tracks to the hull. Step 2. Next attach the right -side tracks to the hull. Below: The left and right track in place on the main hull.
Assembling The Marder II (7.5cm) Tank-hunter (GE103) Assembling The Marder II (7.5cm) Tank-hunter (GE103) Assembling The Marder II (7.5cm) Tank-hunter (GE103)
Below: The gun shield for the Longer Barrled 7.5cm have Left & Right marked backs. Use these to guide your fitting

Step 3a. Attach the left and right gun shields to the 7.5cm gun. As you are doing this a good trick to getting snug fit is to dry fit the completed gun to the main hull as it is drying.

The best way to identify the 7.5cm is by the longer barrel length

Assembling The Marder II (7.5cm) Tank-hunter (GE103) Assembling The Marder II (7.5cm) Tank-hunter (GE103) Assembling The Marder II (7.5cm) Tank-hunter (GE103)
Step 3b. Attach the left and right gun shields to the 10.5cm. As you are doing this a good trick to getting snug fit is to dry fit the completed gun to the main hull as it is drying. Step 4. You can now attach either the 10.5cm or 7.5cm gun to the main hull. You can also leave them unglued allowing you to swap between games.
Assembling The Marder II (7.5cm) Tank-hunter (GE103) Assembling The Marder II (7.5cm) Tank-hunter (GE103) Assembling The Marder II (7.5cm) Tank-hunter (GE103)
Step 5. Insert and glue the loader and commander in the location shown below. Note that there are two different loaders for each gun and have been labeled below. Below: The fully assembled Hotchkiss (7.5cm).
Assembling The Marder II (7.5cm) Tank-hunter (GE103) Assembling The Marder II (7.5cm) Tank-hunter (GE103) Assembling The Marder II (7.5cm) Tank-hunter (GE103)


Last Updated On Thursday, December 5, 2019 by Luke at Battlefront